SMF Civic FS,if it doesnt sell junkyard time!
Posted: Tue Jul 03, 2012 3:58 pm
Well,sadly I have to do this after not even getting to run the car in a SCCA event this year.
1996 Midori Civic DX
D16Y7(nonvtec)
95 Si Trans(quickest ratios available)
All Maintenance is done-New timing belt,water pump etc done within the last 5k miles.
Suspension/Chassis mods:
Ground control spring and sleeves(350lb/in front,450lb/in rear) on "Lotec" shocks
Rear subframe brace with OEM type r rear sway
OEM GSR front strut brace
S&W 8pt roll cage DOM tubing
Hawk HP+ front pads(just put on this year)
TR motorsport 15x8 wheels with RA1s(should last atleast the rest of the season)
Interior:
Tenzo R 6pt compatible seats
G-Force latch link 6pt harness passenger side
Sabelt Camlock 6pt harness on drivers side
Shifter 3" extension on a delsol shifter(points the shifter towards you slightly more)
OMP Pedal set installed to allow for easier Heel toe.
OMP steering wheel
SFI approved padding on main hoop of roll bar
Engine:
AEM Cold air intake
Y8 intake manifold
5degree timing bump
OBX header to OBX catback
I'd like to get 4500/OBO. Make a offer and I'll let you know.
Price does includea lot of stock parts and a full Z6 head thats ready to go on the car for a "mini-me" vtec build. The car will be at verona events as of right now. Feel free to come ask questions. I can be reached at four-three-four-882-1850. Text or call. Email is bruce@evd1980.com
Photos can be viewed here: http://photobucket.com/smfcivic
1996 Midori Civic DX
D16Y7(nonvtec)
95 Si Trans(quickest ratios available)
All Maintenance is done-New timing belt,water pump etc done within the last 5k miles.
Suspension/Chassis mods:
Ground control spring and sleeves(350lb/in front,450lb/in rear) on "Lotec" shocks
Rear subframe brace with OEM type r rear sway
OEM GSR front strut brace
S&W 8pt roll cage DOM tubing
Hawk HP+ front pads(just put on this year)
TR motorsport 15x8 wheels with RA1s(should last atleast the rest of the season)
Interior:
Tenzo R 6pt compatible seats
G-Force latch link 6pt harness passenger side
Sabelt Camlock 6pt harness on drivers side
Shifter 3" extension on a delsol shifter(points the shifter towards you slightly more)
OMP Pedal set installed to allow for easier Heel toe.
OMP steering wheel
SFI approved padding on main hoop of roll bar
Engine:
AEM Cold air intake
Y8 intake manifold
5degree timing bump
OBX header to OBX catback
I'd like to get 4500/OBO. Make a offer and I'll let you know.
Price does includea lot of stock parts and a full Z6 head thats ready to go on the car for a "mini-me" vtec build. The car will be at verona events as of right now. Feel free to come ask questions. I can be reached at four-three-four-882-1850. Text or call. Email is bruce@evd1980.com
Photos can be viewed here: http://photobucket.com/smfcivic