Page 1 of 1
FS: 91 MR2 factory alloys wheels TRD sway bar
Posted: Tue Dec 11, 2007 5:56 pm
by mrtwo
I have a set of nice factory 1991 MR2 wheels (2) 14 x 6 (front) and (2) 14 x 7 (Rear). 5 x 114.3 mm (4 1/2 inch) bolt pattern, 45 mm offset. $100.
I also have a TRD front sway bar. I beleive it fits 1991-95 MR2's. Used 1 season. In good shape. $75
We dont have any more MR2's in the Blue Ridge Region - but if you know of anyone . . .
Tim Russell
540-563-8001
Posted: Sat Apr 26, 2008 7:23 pm
by l33t mr2
I am here!
hey Tim thanks for the great instruction at the rookie event! now I am ready to beat up all those corvettes and loti
-Matt
mr2 alloys
Posted: Mon Jun 23, 2008 5:20 pm
by fspmx6
tim, you wouldnt know where to find a set of 1st gen alloys would you?
Posted: Tue Jun 24, 2008 4:06 pm
by mrtwo
Sorry, I sold my old MR2 wheels to a guy "upsizing" the wheels on his Ford Festiva.
I've still my my 91 MR2 wheels (anyone??), but they will not fit a first gen MR2.
The specs on the 1st gen MR2 wheels is 14 x 5.5 inches wide, 35 to 38 mm offset and a 54.1 mm centerbore. The supercharged MR2 of 88-89 has a 14 x 6 wheel.
If it must be MR2 wheels, try and get the "triangle" type from the 1985-87. The wheels in the 88-89 are heavier.
I think the wheels from the early Toyota FX16, Corolla and Paseo will also fit.
I think the "daisy" wheels from the 1990-93 Miata will also fit, but they have a 45 mm offset.
Hope this helps.
Tim
Posted: Wed Jun 25, 2008 6:18 pm
by fspmx6
well, actually its for a toyota tercel ( same thing as a paseo with a more square body) . i just saw the triangle mr2 wheels on one a while back and they acctually looked good, and since it's the wyf's car and unlikely to be gotten rid of.. much to my dismay. i might as well make it look halfway decent